SNAP CLAMPS
Provides a fast and economical repair to small damages in pipes up to ND 300 caused by corrosion and frost.
They are applied on board of ships and by plumbers for repairs above ground.
RS-0
One band full circumferential clamp with a working range of 4 mm.
In fact it is a small version of the RS-1 clamp, used for the repair of pipes for which a RS-1 is not available (ND of 1/2" up to 2”).
RS-1
One band full circumferential clamp.
Available for pipe OD 44 mm up to including pipe OD 346 mm
Working range 7-11 mm depending on pipe diameter.
RS-2
Double band full circumferential clamp.
Available from range 88-110 up to including range 625-645 mm.
Working range max 22 mm
RS-3
Triple band full circumferential clamp.
Available from range 380-410 up to including range 1.050-1.080 mm.
Working range max 33 mm
Larger pipes can be repaired by our RS-4
(4 band) or RS-5 (5 band) Clamps.
Split Barrel
The Romacon split barrel repair clamp is used for the repair of leaking
couplings, broken AC couplings and high pressure pipes.
Emergency Combi Repair Box
The combi repair clamp box consist of 5 shell sections in different dimensions, allowing a pipe repair for pipes between pipe OD 213 mm and 669 mm.
RS-1A
One band clamp with threaded outlet.
RS-2A
Two band clamp with threaded outlet
RS-CA
One band, half circle, clamp with threaded outlet
RS-C
Designed for pipes with DN 50 up to and including DN 300
RS-C clamps can be used as an economical alternative to RS-1 clamps, but only for local damages.
SST
Two band clamp with flanged outlet.
The upper body is reinforced to accommodate the installation of valves etc.
Light weight for easy installation. Full circle construction for optimal pipe support.
Bolts can point towards the flange or away from it.
SSS
Stainless steel tapping saddle, available from range 68-78 mm and higher.
Threaded outlets from 1/2” -4”.
2 straps for tap sizes over 2”.
A specially grooved ring is embedded in the rubber gasket.
A rubber inlay in the lower shell half is available on request.
INSERTS
Stainless steel insert for the support of HDPE pipes when couplings are used.
The construction gives a circumferential inside support to the pipe ends.
Its thin wall does not disturb the flow characteristics of the medium.
Z- COMBI DUCTILE IRON TAPPING SADDLE
Ductile Iron, epoxy coated tapping saddle
The tapping saddle is suitable to make (hot) taps on Steel / DI / AC and plastic covered pipes.
A special O-ring, combined with a flat ring gasket ensures a high quality connection.
The Z-Combi saddle can be supplied with a BSP tapped outlet and Polva outlet from 1/2” up to incl. 2”.
Available for pipe diameters from DN 40 up to incl. DN 600
products
